| ApplicableValueRatio
|
:
|
Percentage of use requirement or criteria applicable to the space, interpretation depends on the source
type.
|
| ThermalLoadSource
|
:
|
Source of the thermal loss or gain. Depending on the source, the maximum and minimum values have to be
interpreted. Refer to the space usage in Pset_SpaceProgramCommon to determine thermal loads associated
with the activity levels of people.
|
| PropertySource
|
:
|
The source of the space thermal load properties (e.g., are these design values, measured values, etc.).
|
| SourceDescription
|
:
|
Further specification for the source, which might be specific for a region or project. E.g. whether the
heat gain from Person is caused by specific activities.
|
| MaximumValue
|
:
|
The maximum thermal load value. If this value is less than zero (negative), then the thermal load is
lost from the space. If the value is greater than zero (positive), then the thermal load is a gain to
the space. If the minimum value is not specified, then this value is the actual value. At least one of
the maximum, minimum, or time series values must be specified.
|
| MinimumValue
|
:
|
The minimum thermal load value. If this value is less than zero (negative), then the thermal load is
lost from the space. If the value is greater than zero (positive), then the thermal load is a gain to
the space. The requirement for the inclusion of this attribute is dependant on the load source. At least
one of the maximum, minimum, or time series values must be specified.
|
| ThermalLoadTimeSeriesValues
|
:
|
A time series of the thermal load values. If a value is less than zero (negative), then the thermal load
is lost from the space. If the value is greater than zero (positive), then the thermal load is a gain
to the space. These values are contributed from the specified thermal load source. At least one of the
maximum, minimum, or time series values must be specified.
|
| UserDefinedThermalLoadSource
|
:
|
This attribute must be defined if the ThermalLoadSource is USERDEFINED.
|
| UserDefinedPropertySource
|
:
|
This attribute must be defined if the PropertySource is USERDEFINED.
|
| ThermalLoadType
|
:
|
Defines the type of thermal load (e.g., sensible, latent, radiant, etc.).
|
