| PropertySource
|
:
|
The source of the fluid flow properties (e.g., are these design values, measured values, etc.).
|
| FlowConditionTimeSeries
|
:
|
A times series defining the flow condition as a percentage of the cross-sectional area.
|
| VelocityTimeSeries
|
:
|
A time series of velocity values of the fluid.
|
| FlowrateTimeSeries
|
:
|
A time series of flow rate values. Note that either volumetric or mass flow rate values should be specified.
|
| Fluid
|
:
|
The properties of the fluid.
|
| PressureTimeSeries
|
:
|
A time series of pressure values of the fluid.
|
| UserDefinedPropertySource
|
:
|
This attribute must be defined if the PropertySource is USERDEFINED.
|
| TemperatureSingleValue
|
:
|
Temperature of the fluid. For air this value represents the dry bulb temperature.
|
| WetBulbTemperatureSingleValue
|
:
|
Wet bulb temperature of the fluid; only applicable if the fluid is air.
|
| WetBulbTemperatureTimeSeries
|
:
|
Time series of fluid wet bulb temperature values. These values are only applicable if the fluid is air.
|
| TemperatureTimeSeries
|
:
|
Time series of fluid temperature values. For air, these values represent the dry bulb temperature.
|
| FlowrateSingleValue
|
:
|
The flow rate of the fluid. Either a mass or volumetric flow rate shall be defined.
|
| FlowConditionSingleValue
|
:
|
Defines the flow condition as a percentage of the cross-sectional area.
|
| VelocitySingleValue
|
:
|
The velocity of the fluid.
|
| PressureSingleValue
|
:
|
The pressure of the fluid.
|
